皇冠骰宝

Product center
News Center
Location: Home > News

Correct installation method and precautions of servo planetary reducer

2019-09-21 13:48:00


Correct installation, use and maintenance of the servo planetary reducer is an important part to ensure the normal operation of mechanical equipment. Therefore, when installing the servo planetary reducer, please be sure to assemble and use it in strict accordance with the following installation and use related matters.
The first step is to confirm whether the motor and the reducer are intact before installation, and strictly check whether the dimensions of the parts connected to the motor and the reducer match. Here are the dimensions and fitting tolerances of the positioning boss of the motor, the input shaft and the groove of the reducer .
In the second step, unscrew the screws on the dust hole on the outside of the servo planetary reducer flange, adjust the clamping ring of the PCS system so that the side hole is aligned with the dust hole, and insert the hexagon socket to tighten it. After that, remove the motor shaft key.
The third step is to connect the motor and the servo planetary reducer naturally. When connecting, you must ensure that the concentricity of the output shaft of the reducer and the input shaft of the motor are consistent, and the outer flanges of the two are parallel. Like the inconsistency, it will cause the motor shaft to break or the reducer gear to wear.
In addition, during installation, it is strictly forbidden to hit with a hammer or the like to prevent excessive axial or radial forces from damaging the bearings or gears. Be sure to tighten the mounting bolts before tightening the tightening bolts. Before installation, wipe the rust-proof oil on the motor input shaft, positioning boss, and reducer connection area with gasoline or zinc-sodium water. The purpose is to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear.
Before the motor is connected to the servo planetary reducer , the keyway of the motor shaft should be perpendicular to the tightening bolt. To ensure uniform stress, first screw on the mounting bolts in any diagonal position, but do not tighten them, then screw on the other two diagonal mounting bolts, and finally tighten the four mounting bolts one by one. Finally, tighten the tightening bolt. All tightening bolts need to be fixed and checked with the torque wrench according to the indicated fixed torque data.

Zibo Guanyi Transmission Machinery Co., Ltd. http://k-mart19.com/ welcomes your visit. For more information, please Baidu: Guanyi miniature DC motor , Guanyi high power DC motor , Guanyi servo planetary reducer , Guanyi stepping planetary reducer

Ranch
Contact: Manager Zhai | Mobile phone: 18678222209 | Address: Nanyucheng Industrial Park, Economic Development Zone, Boshan District, Zibo Copyright © Zibo Guanyi Transmission Machinery Co., Ltd. Lu ICP No. 19002194